When the battery voltage reads full (my generator is tire driven, so when I stop, only the battery voltage will be displayed) I can disengage my generator from the tire, only needing to engage the generator when the battery voltage drops enough to need charged again. Actually, since I'm connecting it to my power terminal, it will tell me the voltage of the battery as well as the voltage from the charger, so I will always know that my charging circuit is working properly. Anyway, I now have a battery meter that can be mounted to my handlebars (the tail light was the type that mounts on the seatpost, but I'll use the clamp to clamp it to handlebars instead). I tried to take some pics, but the camera on my tablet sucks. After the epoxy cured (I used quiksteel because its what I had, left over from a gas tank repair), I wrapped electric tape around where the epoxy was to ensure the unit would be waterproof. To be clear, the cover of the tail light is removed so that it doesn't interfere with the meter and the meter can be read clearly. Once I had made enough room for the wires and the meter was sitting level, I grabbed some quiksteel epoxy and epoxied the meter into the tail light housing. The wires were getting pinched between the wire connector and the back of the tail light housing. I thought the wires might fit through the hole left by the switch, but I ended up having to make the hole a little bigger before the meter would sit level inside the tail light housing. I removed the cover and the led light strip, as well as the switch that controlled the light. Its a rectangular tail light, the type that you use a coin or flathead screwdriver to pry the cover off to change the batteries. So what I did was I took an old tail light that I no longer use and gutted it to hold the battery meter. You can see from the pics in the link, it doesn't even have a back. I found this one on Amazon for $10: but its not designed for a motorcycle (i.e doesnt come with a handlebar mount), its actually designed to snap into a panel on a boat dashboard. I looked at a few motorcycle battery gauges, but they were way out of my price range. The generator is connected to a charger with a rectifier and regulator, but I don't know if the charger has overcharge protection built-in or not. ![]() ![]() Because I am installing a generator as part of a charging circuit to charge a 12v battery and don't want to overcharge my battery, I wanted a battery meter to tell me when my battery is fully charged so that I can disengage my generator to avoid overcharging.
0 Comments
Leave a Reply. |